i have 2 problems with my ssc-32
problem 1. when i recieved my ssc-32 the eeprom was half out of the socket
when i tried it out it said no eeprom found, i did receated the eeprom
and no go.
problem 2. i have the ssc-32 power by a 9v bat for logic supply and a lipo 5000mah 25c
for the servos like in the powering options in the fourms image #2 all jumpers are set
up like the image #2
A. i hooked up the cylon blue display on pin #31
then in lynxterm i send cmd #31H <cr> and
the display comes on like should.
now the problem, i unhook the lipo bat and the
the display keeps on runing which it should not do
if i have it like in the image #2 in the powering options
which means the LV2 is getting power from some where else
i did remove the jumper from LS=LV1 and left the jumper for
LV1=LV2
B. i did go throught the fourms and didn't see anything like this in the fourms at all
would like to get some help with these problems i am a newbeeee with this stuff but
i learn quick
i am runnig the ssc-32 on a bluesmirfe gold at 115k from my pc at the moment, and got the ssc-32 seq software
and running 12 HSR5990TG on a biped Scout, which i got all of this stuff about 2 weeks ago
just finally got the money to power every thing up, this is the only things i found wrong with the stuff
that i got.
and Jim thanks a lot for your help with my order and combining them together
Login
Register
FAQ
Search
