Putting robotics at your service™

Free shipping on orders over $200

Disarmming Lynx 5

Print view Share :
Previous topicNext topic

Page 1 of 1 [ 2 posts ]

New ( offline )
Posts: 3
Posted: 2009-06-05 01:20 
 Post subject: Disarmming Lynx 5
Hi,

Has anyone ever disarmed the Lynx 5 robotic arm? Is it Easy? because the nylon snap rivet fasteners seem to be hard to be removed. Is there a friendly to do it? I really don't want to disarm it and damaged it all so I have to buy a new one.

Thanks

Lenin


Guru ( offline )
Posts: 2158
Posted: 2009-06-05 09:53 
 Post subject: Re: Disarmming Lynx 5
by disarmed do you mean dis-assemble?

the snap rivets can be pressed back out, usually the easiest way is with the flat of a small screwdriver pressing the tit on the backside until the front side pops up enough to grab it with pliers. you can re-use them although they do eventually take a set and will not be as strong as a new one is. they are cheap enough to replace and usually several extras are packed with anything purchased from lynxmotion that uses them.


 

All times are UTC - 5 hours [ DST ]. It is currently 2014-11-01 06:18
Feedback Form
Feedback Form