Lynxmotion Tech Support

www.lynxmotion.com
It is currently Sun May 19, 2013 7:41 pm

View unanswered posts | View active topics


Board index » Software » General Programming

All times are UTC - 6 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Philtkp
PostPosted: Fri Jan 13, 2012 11:57 pm 
Offline
Roboteer

Joined: Wed Dec 06, 2006 2:24 pm
Posts: 210
Location: Tucson AZ
I've been trying to program something to configure my xbee modules. Using VB Express 2010. But I can't seem to find a way to communicate with the xbee after I change it (ie to 62500 baud rate). I have to reset the xbee back to the defaults. I know its a non standard baudrate. any one know of some references or sample code?
Thanks for any help
Top
 Profile  
 
Philtkp
PostPosted: Sat Jan 28, 2012 9:19 pm 
Offline
Roboteer

Joined: Wed Dec 06, 2006 2:24 pm
Posts: 210
Location: Tucson AZ
I havent been able to find much on non standard buad rates. Just found this on the VBFORUMS but it seem to be a bit over my head. this is waht i've done so far

Attachment:
XBEE TERM.rar [477.86 KiB]
Downloaded 82 times


if you select the 62500 baud rate to config. it work but you will need to manually reset the xbee back
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Software » General Programming

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group