Lynxmotion Tech Support

Hello,

I recently purchased a Wrist Rotate Upgrade (Heavy Duty) Kit with a AL5B arm kit.

My question is about the Ball Bearing and Low Profile Axis Kit LPA-01.

The gear that I received in my kit that goes onto the servo is not as pictured in the instructions, it does not have one side cut out, it is a full gear.

Yes it fits on the the servo, but, there is no way to access the mounting screws on the servo, once the full gear is installed, so that I can adjust the engagement of the gears.

Did I get a bad or wrong gear?

Thanks,

zappman

_________________
Visit the ZappBots Blog/Website at http://zappbots.wordpress.com/
Visit the ZappBots Forums at http://z13.invisionfree.com/zappbots/

We changed to a full gear a while ago. It makes for a more versatile part. You should be able to adjust the gear mesh by removing and replacing the gear and adjusting the servo position.

_________________
Jim Frye, the Robot Guy
http://www.lynxmotion.com
I've always tried to do my best...

I think I'd like the full gears. I have the notched gears.

You might consider drilling an access hole in one of the gears.

Can we order full gears?

Alan KM6VV

_________________
Visit:
http://groups.yahoo.com/group/SherlineCNC/
http://tech.groups.yahoo.com/group/HexapodRobotIK/

Currently the gears are not sold separately. We will look into adding them.

_________________
Jim Frye, the Robot Guy
http://www.lynxmotion.com
I've always tried to do my best...

_________________
Beth
Lynxmotion, Inc
http://www.lynxmotion.com

THANKS I COULD HELP BRO

thanks!

That's one gear I'd like to get cutters for, and make myself (different sizes)!

32 pitch, 50 tooth, 20 DPA gears.

Alan KM6VV

_________________
Visit:
http://groups.yahoo.com/group/SherlineCNC/
http://tech.groups.yahoo.com/group/HexapodRobotIK/